How do you stamp your own jewelry?

Table of Contents

Directions: Align your blank then tape it down onto the metal block just below where you would like to stamp it. Slide your letter stamp down the surface of your piece of metal until you feel the bottom edge of the stamp design catch on the tape. Stop there with the stamp and then strike hard with the hammer one time.

Can you use regular washers for metal stamping?

You’ll need washers, a steel stamp set, hammer, and a permanent sharpie marker. I also used one of those thin flexible plastic cutting boards on top of concrete as a pounding surface. You can use any size washer you want, but I used 1/4 inch washers for the small ones and 5/8 inch washers for the large ones.

Can you do metal stamping with a regular hammer?

Metal Stamping Tools A metal hammer with a flat face; I use a regular hardware-store hammer. A fairly heavy hammer that’s still comfortable for you to use can make your stampings turn out better. (Don’t use your rawhide or nylon jewelry hammers on jewelry stamps – they’ll get torn up quickly.)

What is the best metal to use for stamping jewelry?

Copper – Copper is a very soft, inexpensive metal so it is the recommended choice for beginning stampers. It will take a clear stamp impression and it is easy to find in the market.

How do you practice metal stamping?

Use aluminum foil tape (found at your local hardware store) to practice your design. You can find this at almost any hardware store, but we also sell it here. Lay the tape on a wooden surface and press the stamp into the tape, you may even tap the stamp lightly. This is great for practicing layout and design.

How do you fill stamped metal?

Hold the stamp flush and firmly in place by applying a little bit of pressure and anchoring the side of your hand on your workspace. Strike the stamp once with medium force using metal stamping hammer. Repeat to complete desired word, message, or quote. Remove stamp guide and tape.

What size are the My intent washers?

I just measured a MyIntent washer. They are 7/8″ OD and 3/8″ ID.

What type of hammer is used for metal stamping?

Brass heads work great for striking metal stamps – in fact we recommend always using brass hammers to hit steel stamps. Since brass is a softer metal than steel, this helps prevent your stamps from being damaged. Steel heads come in several styles including chasing hammers and ball pein hammers.