What does E1 F9 mean on a Whirlpool Duet?

drain pump system problem – long drain
If F9 E1 (drain pump system problem – long drain) appears in display, the washer is taking too long to drain water. The drain may extend more than 4.5″ (114 mm) into standpipe. Check plumbing for correct drain hose installation. Use drain hose form and attach securely to drainpipe or tub.

What does E01 and F03 mean on a washing machine?

The error code F03/E01 indicates a problem with the water level. If your washer doesn’t get enough water, it will not be able to work correctly. Most of the time, this error code is a result of a faulty sensor, hose, or brand pipe.

How do I clear the error code on my Whirlpool washer?

To remove the code, press pause or cancel button twice and the power button once. If the code is still displayed, unplug the washer or disconnect the power for one minute. Items were detected in the washer during the Clean Washer cycle. Remove items from the drum and restart the Clean Washer cycle.

How do you fix E1 F9 error on a washing machine?

How to Fix Whirlpool Washer E1/F9 Error Codes

  1. Try a Reset. Sometimes an error code is caused by a control board glitch, where resetting the washer is all it takes to resolve the error code.
  2. Check your Detergent.
  3. Check the Drain Hose.
  4. Clean the Filter.
  5. Check the Drain Pump.
  6. Check the Wiring.

How do I fix error code F9?

Sometimes, the F9 error code is the result of an electrical fault that has magnetized the circuitry. Resetting the oven by disconnecting the power for five minutes will demagnetize the circuitry and resolve the F9 error.

How do I fix error code E1 F3?

F3 E1 Error Code

  1. Power unit down by turning off the circuit breaker or unplugging for one (1) minute.
  2. Power unit up by reconnecting power.
  3. Restart a new cycle.
  4. Monitor the washer for one (1) minute to ensure the error code does not display again.

Why is my washer flashing F02?

What does the error code F02 mean on Whirlpool washing machine front load washer? The F02 error code on a Whirlpool washer indicates that the control detects a long drain time. This can be caused by excessive suds in the tub, a restriction or clog in the drain system, or by a number of other component failures.

What are the Whirlpool error codes?

Error Codes in your Whirlpool Top Load Washer:

Error code Error
LdU Lid cannot unlock.
LF, Lo FL or F8 E1 The washer is taking too long to fill.
lid The washer lid was left open.
Ofb The washer load is out of balance.