How do you bind scalloped edges?
Open the first tail and place the second tail into it, right sides together, to make a 45 degree angle. Pin in place and sew. Once the two ends are joined, clip away the excess, press the binding out flat and stitch the “valley” space closed.
What does scalloped edge mean?
Scalloped is used to describe a series of curves that repeat. So if the edge of your plate has a repeating pattern of humps or curves then it is considered to have a Scalloped edge.
Which stitch is used for making scallops by machine?
Scallop Hems Use a Satin Stitch Foot (additional accessory for some machine models), which will allow the dense stitching to pass freely underneath the foot. Use a wash-away or very light tear-away stabilizer under the fabric.
How wide should a scalloped border be?
I’d recommend having no less than a 2.75″ or 3″ border on your quilt. Keep in mind that if your border is less than 2.5″ or 2.75″ then you’ll be cutting into the block portion of your quilt top when you cut the scallops!
What is scalloped pattern?
What size tail do I start binding with?
Start your binding with a tail of at least 6-8” unsewn. I almost always start on the upside of the “valley” as it rounds over the hill (I put a pin to hold the binding where I plan to start).
Should I tug on the outside curves of bias binding?
You do not want to tug at all on these outside curves because bias binding stretches and will act almost like elastic shrinking back once it has been stitched down. This will give you what we call a tulip petal look once it has been turned to the other side and stitched.
What does a quilt binding look like?
The “hills” and corners should look like lettuce leaves with the binding waffling freely. The “valleys” should look like tulip petals with the binding cupping up off the quilt.